When a floor needs to be flat, sealed and finished in one coordinated system, Mapei is the product family we reach for. Self-leveling compounds, waterproofing membranes and repair mortars all engineered to bond together without gaps or surprises. Detroit Concrete installs Mapei to the published specification, keeping the warranty intact and the slab performing. Call for a free written estimate.
A renovation floor starts with a slab that may be uneven, cracked or damp. Mapei solves each problem in sequence: self-leveling underlayment flattens the surface, waterproofing membrane blocks moisture, and repair mortar patches damage. The key is that all three products are formulated to bond to each other.
When you mix brands, you risk a failure at the layer boundary. Mapei avoids that by engineering primer, leveler, membrane and adhesive as one family. The same discipline applies to our basement waterproofing and commercial floor work.
We follow the Mapei technical data sheet for mix ratios, cure times and temperature. That keeps the product warranty valid and the concrete performing as designed. It is the same approach we take with Sika and Ardex installations.
On the job
Installation sequence
Installing Mapei Concrete in Detroit
Assess substrate and moisture
We test the slab for moisture, cracks and flatness, then select the Mapei product line that matches the conditions and the finish that will go on top.
Profile and prime the concrete
The slab is mechanically profiled to open the pores, then primed with the Mapei primer specified for that product line, not a generic substitute.
Mix, pour and finish per spec
Mapei self-leveling or repair mortar is mixed to the published water ratio, poured at the temperature the spec calls for, and finished to the required profile.
Cure and document the work
Each layer cures on the Mapei schedule. We photograph the install, keep the data sheets and hand you the documentation for warranty and future reference.
System thinking
Why One Mapei Family Beats Mixed Brands
Floor failures often start at a layer boundary, where one product fails to bond to the next. A primer that does not grip the leveler, or a leveler that does not grip the adhesive, creates a weak point that eventually fails under foot traffic or moisture.
Mapei eliminates that risk by engineering all layers to bond to each other. The Ultraplan and Novoplan underlayments are paired with Mapei primers and Mapei adhesives. The waterproofing membranes bond into the same Mapei thinset and tile system. This is the same logic we apply to epoxy garage floors and polished concrete work.
Self-leveling, waterproofing, system compatibility and what Mapei does best in Detroit.
Mapei Ultraplan and Novoplan are tested, predictable products with deep installer support. They pour to a flat, sound surface that takes a finish without telegraphing the slab below, which is exactly what a renovation needs.
Yes, that is one of its strengths. Mapei waterproofing membranes are designed to bond into Mapei thinset and tile adhesives, so the wet-area floor is one continuous system instead of a stack of unrelated layers.
Because every layer boundary is a place where bond failure can happen. Using a single product family means primer, leveler, waterproofing and adhesive are engineered to work together, removing the surprise bond issues.
Yes, when prep is done right. Mapei repair and adhesive products bond patched and existing concrete back to performance spec when the substrate is mechanically profiled and primed correctly.
Yes. We install the published Mapei system, primer, body, finish, in the correct sequence and at the temperature and mix ratio the spec calls for, so the product warranty stays intact.
Client reviews
What Detroit Clients Say About Their Mapei Installs
A renovation floor, a wet-room waterproofing or a repair tied into a finish, tell us the project and we will spec the right Mapei lines and put it in a written quote.
